SEAL-KRETE® High Performance Floor Coatings, Clear-Shell TX, Satin Armor Gray, Gallon Kit
Seal-Krete® Clear-Shell is a textured UV stable fast cure moisture cure urethane that fully cures and accepts vehicle traffic in only 24 hours. The TX additive forms a durable co-polymer matrix when added to SKHP coatings to provide a finish with increased resistance to marring, scratching and abrasion, and delivers a satin-texture appearance that helps hide minor imperfections in the substrate and even out the finish of the coating.
- Color: Armor Gray
- Size: Gallon Kit
- Textured
- UV stable
- Fast cure
- Vehicle traffic ready in 24 hours
- Resistance to marring, scratching, abrasion
- Satin finish
- Hides minor imperfections
| Series/Sub-Brand | High Performance |
|---|---|
| Type | Interior |
| Size | Gallon Kit |
| Color | Armor Gray |
| Brand | Seal Krete |
| Color Family | Gray |
| Finish | Satin |
| Material | Aliphatic Urethane |
| Manufacturer Code | 338795 |
Resin Type: Aliphatic Urethane
Application: Apply only when air, material and floor temperatures are between 50-90°F (10-32°C). Do not apply in direct sunlight or when temperature is rising. Be sure the substrate is completely dry. Pour out only the amount of material to be used into a roller pan. Unused material can be saved in the mixing container for up to 6 months provided it is properly sealed. Do not return unused material from the roller pan to the mixing container. Use a 3/8 in. lint free roller with a phenolic core to roll out the coating. Begin with rolling out a W or M pattern, then cross roll to fill in and smooth out the coating.
Coverage: 400 sq. ft. per gallon, Coverage rate can vary depending on the texture and porosity of the concrete
Dry Times: Recoat in 4-12 hours, Light Traffic 4-6 hours, Vehicle Traffic 24 hours
Pot Life: 6 months once stabilizer/tint has been added
Mixing Ratio: Both components and environment should be pre-conditioned to a minimum of 50º F (10º C) prior to use. Be sure the air and surface temperatures are at least 5º above the dew point. Clear-Shell TX is moisture sensitive, so be sure the outside of the containers are dry and free of condensation. Shake the container of Stabilized/Tint for one full minute before combining with the Clear-Shell TX. The components can be mixed in a separate container or mixed in the gallon can. After combining the components, power mix at 500-700 rpm for 2-3 minutes. Use an appropriate size mixer and use care to not entrain air into the coating while mixing. Once mixed, the material has a 6 month shelf life.
DO NOT hand mix.Clean Up: Clean tools and application equipment immediately after use with an active solvent like Methyl Ethyl Ketone (MEK).