SEAL-KRETE® High Performance Floor Coatings, Poly-Shell 7000, Clear, Satin, 2 Gallon Kit
Seal-Krete® Poly-Shell™ 7000 utilizes the latest development in Polyaspartic coating technology and is the most durable coating available. It dries quickly and provides unparalleled rapid return to service. It is extremely resistant to heat (temps up to 350°F), UV rays, and a variety of harsh chemicals, including salt, oil, and gasoline. Poly-Shell 7000 is also flexible and allows for natural concrete movement without cracking or peeling, making this system ideal for either indoor or outdoor applications.
- 2 Gallon Kit
- VOC less than 50 g/l, SCAQMD Approved
- Versatile Coatings, Broadcast Floors, Chip Floors,Slurry, and Broadcast
- Rapid Return to Service in 24 hours
- Outstanding Color retention in Gloss or Satin Finish
- Highly Chemical Resistant (for more information, see technical data page)
- Convenient 1:1 mixing ratio
- Designed for interior and exterior applications
| Series/Sub-Brand | High Performance |
|---|---|
| Type | Interior |
| Size | 2 Gallon Kit |
| Color | Clear |
| Brand | Seal Krete |
| Finish | Satin |
| Material | Polyaspartic Polyurea |
| Manufacturer Code | 244002 |
Resin Type: Polyaspartic Polyurea
Application: Apply only when air, material and floor temperatures are between 50-90°F (10-32°C). Do not apply in direct sunlight or when temperature is rising. Be sure the substrate is completely dry.
Coverage: 120-240 sq. ft. per gallon. Coverage rates will vary based on application method.
Dry Times: Recoat in 2-12 hours, Light Traffic 2-4 hours, Vehicle Traffic 24 hours, Full Cure 7 days
Re-Coat Window: minimum wait time 2 hours, maximum wait time 12 hours
Pot Life: 35-40 minutes at 70-80°F (21-27°C) and 50% Relative Humidity
Note:Before starting, ensure that the material, concrete surface, and the ambient air are all at 30-90°F. Mixing ratio is 1 part A to 1 part B.
Mixing Ratio: Pre-mix both A and B sides prior to combining. Add part A to the mixing container. Add part B to the mixing container and mix for 60-90 seconds. After combining components, use a low speed drill and spiral mixing wand for 2-3 minutes. Use an appropriate size mixer and use care not to intermix air into the coating while mixing. DO NOT hand mix.
Clean Up: Clean tools and application equipment immediately after use with an active solvent like xylene. Clean spills or drips while still wet with solvent. Dried product will require mechanical abrasion for removal.