SEAL-KRETE® High Performance Floor Coatings, Dura-Shell Clear Matte, Gallon Kit
Seal-Krete® Dura-Shell™ WB is a High Solids premium clear water-based two-part high performance urethane coating which utilizes aliphatic urethane polymer technology. It provides excellent film hardness, chemical, abrasion and UV resistance with less than 50 grams per liter of VOCs, it is approved for usin South Coast Air Quality Managment Districkt (SCAQMD). Dura-Shell can be applied directly to many surfaces without the need of a primer, i.e., concrete, wood, aluminum and galvanized metal. The coating is widely used to provide a high gloss or matte finish to concrete floors, food & beverage and pharmaceutical facilities. It is recommended on floors and walls in equipment and clean rooms, as well as amusements parks, refineries, power industry, storage tank exteriors and wastewater facilities.
- Size: Gallon Kit
- Matte Finish
- UV resistant
- Non-yellowing
- Great scratch resistance
- Recommended as anti-graffiti topcoat
- Low odor formula
- Excellent hot tire pick-up resistance
- Recommended for vertical or horizontal applications
| Series/Sub-Brand | High Performance |
|---|---|
| Type | Interior |
| Size | Gallon Kit |
| Color | Clear |
| Brand | Seal Krete |
| Finish | Matte |
| Material | Water-Based Urethane |
| Manufacturer Code | 224001 |
Resin Type: Water based urethane
Application: Apply only when air, material and floor temperatures are between 50-90°F (10-32°C). Do not apply in direct sunlight or when temperature is rising. Be sure the substrate is completely dry.
Coverage: 300-500 sq. ft. per gallon. Coverage rates will vary based on application method.
Dry Times:Recoat- Minimum 6 hours and maximum wait time 24 hours, Tack Free 6 hours, Vehicle Traffic 5 days
Pot Life: 60 minutes at 70-80°F (21-27°C) and 50% Relative Humidity
Note:Before starting, ensure that the material, concrete surface, and the ambient air are all at 50-90°F.
Mixing Ratio: Mixing ratio is 3 part A to 1 (base) part B (activator). Pre-mix both A and B sides prior to combining. Add part A to the mixing container. Add part B to the mixing container and mix for 60-90 seconds. Mix only the amount of material that can be applied during the pot life (approximately 1 hour, depending on air/surface temperatures). Do not aerate the mix. Apply immediatly. After combining components, use a low speed drill and spiral mixing wand for 1-2 minutes. Use an appropriate size mixer and use care not to intermix air into the coating while mixing. DO NOT hand mix as hand mixing will produce inconsistent results and is not an approved method.
Clean Up: Clean tools and application equipment immediately after use with an active solvent like xylene. Clean spills or drips while still wet with solvent. Dried product will require mechanical abrasion for removal.