SEAL-KRETE® High Performance Floor Coatings, Clear-Shell, Clear Gloss, Gallon
Seal-Krete® Clear-Shell is a Single Component Aliphatic Moisture Cure Urethane Clear Coating. Seal-Krete Clear-Shell provides a strong, beautiful, and maintenance-free finish. Clear-Shell can be used as a final topcoat over broadcast floors, chip floors, slurry/broadcast, metallic epoxy, acid stains, and concrete stains.
- Versatile - Final Topcoat over Broadcast Floors, Chip Floors, Slurry/Broadcast, Metallic Epoxy, Acid Stains, Concrete Stains
- Return to Service in 48 hours
- Properties equal to two part polyurethanes
- VOC Compliant
- Outstanding Gloss Retention
- Highly Chemical Resistant
- Packaging Size: 1-Gallon
Recommended Uses:
- Warehouse and Garage Floors
- Manufacturing Plants, Workshops
- Veterinarian Clinics and hospitals
- Production Rooms and Loading Docks
| Series/Sub-Brand | High Performance |
|---|---|
| Type | Interior |
| Size | Gallon |
| Color | Clear |
| Brand | Seal Krete |
| Finish | Gloss |
| Material | Aliphatic Urethane |
| Manufacturer Code | 246001 |
Resin Type: Aliphatic Urethane
Application: Temperatures should be maintained between 50–90°F and should not fall below 50°F within 24 hours of application. Do not apply if rain is expected within 12 hours. DO NOT USE OVER WATER-BASED PRODUCTS. Do not apply to glazed tile, marble, granite or other non-porous substrates. Do not use on concrete slabs with inadequately drained sub-grade, treated surfaces to be covered with concrete or plaster, and/or surfaces subject to hydrostatic water pressure. Do not thin or dilute. Do not apply in direct sunlight in high heat conditions. Do not apply if surface temperature is within 5°F of the dew point in the work area. Films applied above 6 mils wet could results in tiny bubbles dried in the film due to carbon dioxide gassing. If not stored in sealed containers coating may develop a thin skin on top.
Coverage: 250-400 sq. ft. per gallon using 1/4 in. roller at 4-6 mils, depending on surface porosity and application method. Second coat will render 50% greater coverage per gallon. Coverage rate can vary depending on the texture and porosity of the concrete
Dry Times: To Touch 30 minutes, Recoat in 6-8 hours, Foot Traffic 24 hours, Vehicle Traffic 48 hours, Full Cure 7 Days
Pot Life: 3 years
Mixing Ratio: Low speed drill and spiral mixing wand. Important: Hand mixing will produce inconsistent results and is not an approved method. DO NOT SHAKE. DO NOT THIN.
Clean Up: Clean tools with solvents Xylene immediately after use. Dispose of container and contents in accordance with local laws and regulations. Store in a cool, dry area. Dried material will require mechanical abrasion or chemical strip for removal. Do not use alcohol “IPA” or Lacquer thinner blends that contain alcohol to clean equipment or tools.