Rust-Oleum® Stops Rust®, Automotive Primer, Flat, Oil-Based, Spray Paint, 12 oz.

Surface Preparation: Remove all dirt, grease, oil, salt and chemical contaminants by washing the surface with a commercial detergent, or other suitable cleaning method. Rinse with fresh water and allow to thoroughly dry. Remove loose paint and rust with a wire brush or sandpaper. Previously coated surfaces must be sound and in good condition. Smooth, hard, or glossy finishes should be scarified by sanding to create a surface profile.

Application:Shake can vigorously for one minute after the mixing ball begins to rattle. If mixing ball fails to rattle DO NOT STRIKE CAN. Contact Rust-Oleum. Shake often during use. Hold can upright 10-16" from surface and spray in a steady back-andforth motion, slightly overlapping each stroke. Keep the can the same distance from the surface. Keep the can in motion while spraying. Apply two or more light coats a few minutes apart to avoid drips and runs. Do not use near open flame.

Recoat:Dry and recoat times are based on 70ºF and 50% relative humidity. Allow more time at cooler temperatures. Dries to the touch in 15-30 minutes, to handle in 1-2 hours and fully dry in 48 hours. Apply a topcoat or recoat within 1 hour or after 48 hours. Wait 4 hours before dry sanding.Clean-UpWipe off tip when finished. Clean-up wet paint with xylene or mineral spirits. Properly discard empty container. Do not burn or place in home trash compactor.

Clogging: After use, turn can upside down and press spray nozzle until spray is clear to prevent clogging. If the valve clogs, twist and pull off spray tip and rinse in a solvent such as mineral spirits. Do not insert any object into can valve opening.