Chat with us, powered by LiveChat

INSL-X STIX Waterborne Bonding Primer, 5 Gallon

In stock
Only %1 left
SKU
STIX5
 
 

Stix® Waterborne Bonding Primer is a premium quality, waterborne, acrylic urethane primer/sealer with unparalleled adhesion to the most challenging surfaces, including PVC, Vinyl, Most Plastics, Glass, Tile, Glazed Block, Glossy Paints, Pre-Coated Siding, Fiberglass, and Galvanized Metals. Stix is also ideal for use on plaster, drywall, wood, and non-ferrous metals, where a low ambient or surface temperature would present a problem for conventional primers. Offers an extremely hard film when cured. Use it on interior and exterior surfaces and topcoat with almost any type of coating including Alkyd, Acrylic Latex, Urethane, Epoxy, and Lacquer Finishes. Stix levels to a smooth surface and cleans up with soap and water.



As low as $414.99
each
Select a store
32 Available in stock
Delivery
Available
  • Strongly Bonds to Glossy Surfaces.
  • Unparalleled Adhesion to the Most Challenging Surfaces.
  • Excellent Holdout
  • Soap & Water Clean-up
More Information
Series/Sub-BrandInsl-X
TypeInterior/Exterior
Size5 Gallon
ColorWhite
BrandINSL-X
MaterialWater-Based
Application: Stix® may be applied by brush, roller, pad applicator, or airless spray. Use a high quality nylon brush or a 1/4 in. – 1/2 in. synthetic nap roller cover. Do not thin. Do not apply when surface, air, or product temperature is below 35 °F. Do not paint in direct sun or on a hot surface. If possible, plan your painting to avoid rain, moisture, or high humidity for the first 24 hours of curing. Stop application a minimum of two hours before rain or dew is expected. Do not paint if surface temperature is within 5 °F of the dew point. When top coating with two component paints, allow 24 hours dry time before painting. Always test questionable substrates such as plastics, composites, Kynars, and polyester surfaces by applying a small area for adhesion and top-coat compatibility before proceeding with the entire job. 

Airless Spray: Tip range between .013 and .017. Total fluid output pressure at the tip should not be less than 2200 PSI. Preferred pressure is 2500 PSI.

Dry Time: 1 Hour to Touch, 2 Hours to Recoat

Clean-up: Soap and Water

Coverage: 300 – 400 Sq. Ft. per gallon

Write Your Own Review
You're reviewing:INSL-X STIX Waterborne Bonding Primer, 5 Gallon
Your Rating