Insl-x Multi-Surface Waterproofer, Clear, Gallon
Multi-Surface Waterproofer is a penetrating, siloxane-based water repellent. Once fully absorbed and dry, this clear waterproofer will seal and protect the surface without changing its visual appearance or texture.
Recommended For: Use on interior or exterior properly prepared new or reconditioned concrete, brick, wood, stucco and masonry substrates.
Note: Apply when surface and ambient temperature is above 40 °F and below 90 °F Not for immersion service or areas of pooling water
- Protects and seals
- Dries clear with no visible change to the substrate
- Penetrating siloxane-based formula
- Easy soap & water clean-up
| Series/Sub-Brand | Insl-X |
|---|---|
| Type | Interior/Exterior |
| Size | Gallon |
| Color | Clear |
| Brand | INSL-X |
| Material | Water-Based |
| Manufacturer Code | WPS1000099-01 |
Application: Multi-Surface Waterproofer applies easily with a pump sprayer. Lowpressure airless spray can also be used. If using airless spray equipment, we recommend a spray tip size of .035 - .051. This product is not intended to be atomized or misted onto the surface. Apply using overlapping passes starting from the top. Should the product start to drip, backroll with a short nap roller to ensure an even application. Use a quality brush to remove any drips or puddling of the product if a roller cannot be used. Stir product thoroughly before using. Apply when surface and ambient temperature are above 40 °F and below 90 °F. Avoid application outside when weather conditions are threatening, and late in the afternoon when there is a threat of moisture condensing on wet product. Do not use if surface temperature is within 5 °F of the dew point.
Coverage: Cement block 50-100 Sq. Ft. per gallon, Poured concrete 100-200 Sq. Ft. per gallon, Stuccon 100-200 Sq. Ft. per gallon, Wood up to 300 Sq. Ft. per gallon.
Clean-up: Clean up with warm soapy water
Dry Time: Tack free 2 - 3 hours, Back to service - 12 hours
Maintenance: Surfaces should be checked each year to ensure integrity of the coating. Perform a splash test on the surface and if water absorbs quickly, apply an additional coat of the product.