Huber AdvanTech Subfloor Adhesive Starter Kit
Huber AdvanTech subfloor adhesive is a high-performance, gun-applied foam-to-gel polurethane construction adhesive designed to aggressively bond OSB, plywood and AdvanTech subfloor panels to the supporting framing. A moisture-curing polyurethane resin adhesive, it bonds subfloor panels and joist even in wet and frozed weather conditions. It dipenses from the applicator gun as a foam bead of ahdesive that settles into a gel adhesive in a few seconds. The gap-filling properties allow it to bridge minor imperfections or gaps found on irregular application surfaces. Included in this starter kit: 6 cans of AdvanTech Subfloor Adhesive, 24 oz., 1 can AdvanTech Subfloor Adhesive Cleaner, 12 oz. and 1 AdvanTech Adhesive Applicator Gun, 14 in.
$224.99
each
- Adhesive: One 24 oz. can yields approximately 400 linear feet of adhesive at 1/2 in. diameter foam bead (3/8 in. gel bead)
- Open time of 20 minutes, fully cured in 24 hours
- Partially used cans can be reused for up to 30 days after initial attachment to the applicator gun
- See installation instructions for warranty information and guidelines for use
- AdvanTech Adhesive Gun required (sold separately) Cleaner: Keep away from heat and direct sunlight
- Use only in well-ventilated areas
- Additional instructions listed on the AdvanTech Professional Applicator Gun Maintenance/ Use Techincal Tip sheet and the Huber SDS sheet
| Type | Adhesive |
|---|---|
| Brand | Huber |
Write Your Own Review
