JELD-WEN 30 in. x 80 in. 6 Panel Colonist Smooth Finish Hollow Core Interior Door Right-Handed Unit
Jeld-Wen Molded Wood Composite Doors are affordable, stylish and environmentally friendly interior doors. Hollow Core primed doors are a combination wood and MDF frame in 1-3/8 in. door. Because of the Hollow Core, these doors work great for closets and areas where noise is not an issue.
This Colonist Smooth face door are Pre-hung units, framed with 4-9/16 in. primed finger-jointed flatboard jambs with colonial stops, 2-3/8 in. standard single bore, and (3) 3-1/2 Radius Brasstone Hinges.
Casing sold separately
As low as $196.99
each
- Cove & Bead Sticking
- Light Weight & Durable
- Scientific Certifications Systems (SCS) for recycled content.
- Learn more about How to Measure a Door here.
- Or about the Anatomy of an Interior door.
| Type | Interior Doors |
|---|---|
| Brand | Jeld-Wen |
| Finish | Primed |
| Material | Composite |
| Door Type | 6 Panel |
| Door Configuration | Single Pre-Hung |
| Door Style | Traditional |
| Door Core | Hollow Core |
| Door Size | 30 in. x 80 in. (2/6 x 6/8) |
| Rough Opening | 36-1/4 in. x 82-1/2 in. |
| Door Swing | Right Hand |
| Door Thickness | 1-3/8 in. |
| Jamb Type | 4-9/16 in. Primed FJ Flat Board Jamb with Colonial Stop |
| Hinge Finish | Brasstone (3LB) |
| Manufacturer Code | 8100099872 |
Storage & Handling
- Always handle doors with clean hands or while wearing clean gloves
- Doors should not be at a job site until concrete floors, foundations and plaster walls are thoroughly dry.
- Doors should not be exposed to excessive moisture, head, dryness or direct sunlight
Installation
- Doors should be conditioned to average prevailing relative humidity of the locality before fitting
- Do not cut doors down in size more than 1/2 in. width (1/4 in. each side) or 2 in. in height (1/2 in. from top of door, or up to 1-1/2 in. from bottom of door*)
- Allow 1/8 in. clearance between doro and frame at the top and sides of the unit.
- Be sure that jambs and stops are set perfectly square and plumb, shim and fasten every 2 feet.
- Use (3) hinges on doors 7 ft. or less in height
- Special preparataion is requed with mortise locks, please contact us for more information if needed.
Finishing
- Finish must be applied to the door immediately after fitting and hanging, but not during or immediately after high-moisture periods.
- Surfaces must beclean and dry
- Sand entire door lightly with 180 grit sandpaper
- Finish all (6) sides, this induldes edges, tops and bottoms.
Write Your Own Review