Benjamin Moore High Performance, Acrylic Metal Primer, White, Gallon
Benjamin Moore High Performance, HP1100 Acrylic Metal Primer is a water reducible, rust inhibitive primer formulated for use on steel, iron, and non-ferrous metals. The product provides excellent adhesion to a wide variety of hard to coat surfaces. Designed for light to moderate industrial exposures, this product may be top coated with a wide variety of coating chemistries. Additionally, this product may be applied to properly prepared steel as well as tightly adhering rust. Suitable for use in USDA inspected facilities.
$60.79
each
- Rust Inhibitive
- Recoat in 2 hours
- Excellent for ferrous and non-ferrous metals
| Series/Sub-Brand | High Performance |
|---|---|
| Type | Interior/Exterior |
| Size | Gallon |
| Color | White |
| Brand | Benjamin Moore |
| Material | Water-Based |
| Manufacturer Code | HP1100 |
Surface Preparation: All grease, oil, dirt, mildew, or any other surface contaminants must be removed using HP6000 Oil & Grease Emulsifier or SSPC-SP1 solvent cleaning.
Ferrous Metal: All loose rust and mill scale should be removed prior to applying this product. A minimum of Commercial Blast or abrasive blasting is recommended for severe environmental exposures. Small areas may be cleaned in accordance with Hand Tool Cleaning or Power
Tool Cleaning or Power Tool Cleaning to bare metal. Tightly adhering rust may be coated over provided the surface is intended for use in mild atmospheric exposures.
Non-Ferrous Metal (Galvanized, Aluminum, etc.): Remove surface contaminants using HP6000 Oil & Grease Emulsifier or SSPC-SP1 solvent cleaning.
Previously Painted Surfaces: Clean using HP6000 Oil & Grease Emulsifier or solvent washed as outlined above. Dull glossy surfaces by sanding. Remove all loose, flaking or peeling paint prior to application.
Coverage: 300-400 Sq. Ft. Wet film thickness 4.0-5.3 mils, Dry film thickness of 1.8 -2.3mils. Depending on surface texture and porosity.
Dry Time: To Touch in 30 minutes, To Recoat in 2 hours, at 77°F and 50% relative humidity. Recoat after 72 hours: abrade the surface to ensure poper inter-coat adheasion. Surface temperatures minimum 50°F and maximum of 90°F.
Clean Up: Clean all equipment immediately after using with soap and water. Spray equipment should be given a final rinse with mineral spirits to prevent corrosion.
Write Your Own Review